Today was my turn to be on the spotlight over at Jane's Doodles and I made this CAS (clean and simple), Awesome Card.
For this card I used Jane's Doodles 'Cactus' stamp set, I love it so much!! :o)
How I made this card...
For the image I went with masking and paper piecing.
I stamped a cactus pot on a white carstock paper panel using pre-made masks. I colored the pot with a black marker. I masked a sentiment from the set and stamped part of it on the panel.
Then I stamped the pot twice on a designer paper, stamped other part of the sentiment on one pot, fussy cut pieces I needed and colored their edges with black marker.
Before I decided what media will I use for coloring, I made a decision about the design of my card. I cut out a stripe of the designer paper, same I used for pot, and glued it on a top folded white cardstock card base. I also trimmed the panel to be narrower than the card base.
Next up was coloring. I colored plants with Distress Inks and super thin paint brush which I bought last week. It's great! :o)
I colored directly on the cardstock panel, so I had to add small amount of water while coloring to avoid cardstock getting too wet.
Next up was card assembling. I glued pot pieces together and glued them on the panel over the black pot. Then I cut out a rectangle, slightly smaller than the panel, from 1 mm thick foam sheet. I glued the foam on the back of the panel, glued the panel on the card base and my card was finished. :o)
Card dimensions: 101 mm x 133 mm (4" x 5 1/4")
- Jane's Doodles 'Cactus' stamp set
- white cardstock paper
- designer paper from Create a Smile 'Sending Sunshine' kit
- Ranger's Archival Ink (Jet Black)
- Tim Holtz's Distress Inks
- Mustard Seed
- Spiced Marmalade
- Twisted Citron
- Cracked Pistachio
- Stabilo Fine Tip Pens 68 (Markers)
- green 36
- black 46
- Staedtler Lumocolor permanent black pen S (superfine) 0.4 mm
- double sided strong adhesive tape
- A4 foam sheet, 1 mm thick
- Fiskars High Precission Personal Paper Trimmer
- Sigma Rotary Paper Trimmer
- acrylic block (102 mm x 102 mm)
- Marabu fine rounded paint brush no. 3/0
- scissors
- water
- paper towels
- Micropore surgical tape (for masking)
4) 613 Avenue Create, Challenge #190 - Anything Goes
This is my 1st entry to this challenge.
Thank you for visiting and your kind feedback. Enjoy and smile! :o)
Milka
Great design for your cactus CAS, Milka!! Love very much the stripe of DP that matches perfectly with the vase and adds a beautiful dimension!! The cactus plants are just adorable and perfectly coloured!
ReplyDeleteHugs
baš je fora!
ReplyDeleteLp
A sweet CAS card design, love those stamps too. Thanks for sharing it with us at 613 Avenue Create.
ReplyDeleteLorraine DT
Thank you for your comment on my blog, your card took some intricate masking, it's awesome
ReplyDeleteA fabulous CAS card hun.
ReplyDeleteThank you for joining us at Noor Design UK, hope you will join us in our next challenge. Good luck hun.
Lotsa hugs Vicky xxx